Inspect a Forklift
There are over 10,000 workplace injuries connected to forklifts happen each year, based on OSHA and HRSDC reports. A lot of these accidents are caused by driver error. Lack of proper equipment maintenance and check causes numerous others. Forklift maintenance and operation is not just the reason for personal injuries, but also of damage to property. Forklifts could damage building structures, overhead pipes and sprinklers, and other equipment when wrongly operated. The following day by day check ups should be done in order to lessen the chance of forklift accidents.
Prior to inspecting various fluid levels turn the engine off. Inspect these fluids: hydraulic oil, fuel, engine oil, brake fluid and coolant. The tires also need to be checked for signs of wear and tear. Check the air pressure in the tires. Check the forks' condition. The load backrest must be attached tightly. Do a visual check of the top-clip retaining heel and pin. After that perform an inspection of the mast chains, hydraulic hoses, cables and stops. Make certain that both the overhead and finger guards are securely attached.
LP forklifts have propane tanks that have to be inspected for signs of corrosion, damage or rust. Test the battery's electrolyte levels and charge. All belts must be inspected for wear. Check to make sure the owner's handbook is stored on-board the forklift in a storage compartment. Check the seat belt to make certain the latches are secure. Check the hood latch to make certain that it is functioning as it should.
To make certain there are no unusual engine sounds, start the engine up and listen for any irregularities. If there are, investigate promptly. Test the accelerator and the steering controls. The service brake and the parking break must be correctly functioning.
To ensure proper functioning in both forward and reverse, the drive control and tilt control must be inspected. The functioning of the hoist, the lowering control and attachment control requires periodic checking. Check the horn and lights. After that check the wipers, heater and defroster to make certain they are working well. Check each and every gauge to find out that it is reading within functional limits.